Mounting Bracket for Divers Helmet Lamps

Cast Brass Bracket (Rear Facing)
Oval mounting base (undrilled) 76mm tall x 31mm wide, mounting bar 80mm long with lamp spade parallel to base for fitting on the rear of a vehicle, spade dimensions 30mm wide x 41mm tall x 5mm thick. Sold individually. Supplied undrilled

Cast Brass Bracket (Side Facing)
Oval mounting base (undrilled) 76mm tall x 31mm wide, mounting bar 80mm long with lamp spade at 90° to base for fitting on the side of a vehicle, spade dimensions 30mm wide x 41mm tall x 5mm thick. Sold individually. Supplied undrilled

Steel Bracket 
Overall height approx 125mm. Fitting to the car (rear chassis cross member) can be via a U bolt. The spade can be drilled if required to thread the rear lamp bolt through. Flat blades measures approx 24mm wide x 4mm thick and 29mm wide x 3mm thick for lamp. Sold individually. Supplied undrilled.

Nickel Plated Brass Bracket (Rear Facing)
Oval mounting base (undrilled) 76mm tall x 31mm wide, mounting bar 80mm long with lamp spade parallel to base for fitting on the rear of a vehicle, spade dimensions 30mm wide x 41mm tall x 5mm thick. The base is drilled with 8mm holes at 45mm centres.  Sold as a PAIR. Please note – these are sand castings, so cannot be plated to the same standard as bronze lost wax/investment castings and there will be some slight marks in places in the plating. A very nice mounting set for our nickel-plated CA1177 series lamps.