1.5″ Leather Bonnet Strap Kit – Lined

Premium 1 1/2″ leather bonnet strap (padded) with fitting kit. Held in stock for customer fitting. Available in high-quality brown or black leather. 1.5″ wide (38mm).
1 1/4″ and 2″ widths are also available. This pattern is made as a two-part strap – with the buckle on one strap and the pointed end on the plain other.

Standard features of this premium strap:

• Felt non-scratch wool lining – stitched
• One fixed and one sliding leather keep
• Buckle protector featuring 30mm diameter ‘Toby’ stamp
• Polished stainless steel belt buckle
• 5 pre-punched holes in the plain end
• Buckle side of strap – 66cm to the base of the buckle, 71cm including buckle protector
• Tail end of strap – 153cm
• Buckle protector 6cm square

The TOBY Premium Bonnet Strap kit is supplied with two chrome-on-brass staple loops for 1.5″ belts, a leather hole punch and 4 stainless steel Chicago screws. Leather rivets are available online, but TOBY recommends and supplies Chicago screws for ease of use.

Instructions: Assemble the strap over the bonnet and measure up the required fitted length of belt allowing for approximately 3″ to be fed through the mounting staples, doubled back and riveted back to the strap. Most people assemble the bonnet strap with the buckle pin in the middle hole to allow adjustment. Then cut the ends of the straps to the length required, doubling them through the staples and securing with the screws through the holes you make with the leather punch supplied.

The buckle protector of this super bonnet strip is embossed with the ‘Toby’ logo, 30mm in diameter. ‘Toby Mitchell – London NW1’ is the mark Vintage Supplies has applied to authentic reproductions of the finest period motoring accessories for over 30 years.